Zebra 77660 用户手册
72
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
Replace Latch Kit
Caution • Turn Off (O) the printer and disconnect the printer from the power
source before performing the following maintenance.
source before performing the following maintenance.
Remove Latch
1.
Turn Off (
O
) the printer and disconnect the AC power cord and data cables.
2.
Open the media door and remove the ribbon and media.
3.
Refer to Figure 4-11. Remove the strike plate cap by prying up on the front edge
with a small screwdriver.
with a small screwdriver.
4.
Remove the latch cover by prying out on the front edge with a small screwdriver.
5.
Remove the two screws securing the strike plate to the side of the print mechanism.
6.
Pull out on the bottom of the strike plate while removing the adjustment screw from
the print mechanism.
the print mechanism.
Figure 4-11. Latch Kit Parts
Caution • Wear protective eyewear when removing E-rings, C-clips, snaprings,
and springs. These are under tension and could fly off while removing.
and springs. These are under tension and could fly off while removing.
Strike Plate
Cap
Strike
Plate
Strike Plate
Mounting
Screws
Latch Cover
Latch
Spring
Spring
Pin
Adjustment
Screw
Print
Mechanism
Platen
Housing
Ribbon Guide
Plate
Front Edge
Front Edge
Washer
Pin Gauge
Adjustment
Cam
Cam Mounting
Screw