Zebra 77660 用户手册
74
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
Figure 4-13. Adjustment Screw Location
5.
Refer to Figure 4-14. Tighten the adjustment screw until the top of the strike plate is
just below the top of the ribbon guide plate.
just below the top of the ribbon guide plate.
6.
Refer to Figure 4-12. Insert the two mounting screws and washer through the strike
plate and into the print mechanism. Do not tighten at this time; leave them
approximately ½ turn loose.
plate and into the print mechanism. Do not tighten at this time; leave them
approximately ½ turn loose.
7.
Latch the print mechanism.
Strike
Plate
Adjustment
Screw
Adjustment
Screw
Shoulder