Zebra 77660 用户手册
13358L Rev. 1 11/17/03
Z4Mplus and Z6Mplus Maintenance Manual
73
Preventive and Corrective Maintenance
Section 4
7.
Using a small punch, very lightly tap the spring pin from the rear of the platen
housing until it is free from the latch and can be removed.
housing until it is free from the latch and can be removed.
8.
Remove the latch and compression spring.
Install Latch
1.
Refer to Figure 4-11. Install the compression spring on platen housing post.
2.
Align latch with spring pin holes. Insert the spring pin through the front hole of the
latch and though the platen housing. The rear hole in the latch is the only small one
and you will need to tap on the spring pin. Lightly tap the spring pin into the rear
hole. Leave equal amounts of spring pin sticking out on each side of latch.
latch and though the platen housing. The rear hole in the latch is the only small one
and you will need to tap on the spring pin. Lightly tap the spring pin into the rear
hole. Leave equal amounts of spring pin sticking out on each side of latch.
3.
Install the strike plate partially into print mechanism by sliding the short side to the
inside of print mechanism as seen in Figure 4-12.
inside of print mechanism as seen in Figure 4-12.
Figure 4-12. Strike Plate Installation
4.
Install the adjustment screw into the strike plate by sliding it in the opening as seen
in Figure 4-13.
in Figure 4-13.
Note •
The spring pin must be tapped out from the rear and removed from the front of
the platen housing. Trying to remove the pin in the other direction will damage the platen
housing.
housing.
Short
Side
Adjustment
Screw
Mounting
Screws
Short Side
in here
Long Side
Here
Print
Mechanism
Washer