Cisco FL-GK-NEW-3745= 用户手册
Chapter 2 Configuring Hosted Unified Communications Services Components Before Loading Bulk Data
Applying Static Configuration to the Cisco HSI
2-34
Getting Started with Cisco Hosted Unified Communication Services
OL-15490-01
Example 2-9
RAS Parameters
prov-add:name=ras,gatekeeperId=HUCS_ZONE
prov-add:name=ras,gateway.prefix[1]=999#
prov-add:name=ras,manualDiscovery.ipAddress=<gatekeeper_ip_address>,
for example:
prov-add:name=ras,manualDiscovery.ipAddress=10.120.4.51
prov-add:name=ras,manualDiscovery.port=1719
prov-add:name=ras,terminalAlias[1].h323ID=<hsi_name>, for example:
prov-add:name=ras,terminalAlias[1].h323ID=hsi-ent4a@cisco.com
illustrates the Hosted UCS- specific static configuration settings
required to support T.38 fax:
Example 2-10 T.38 fax support
illustrates the Hosted UCS- specific static configuration settings
required on all HSIs.
prov-add:name=sys_config_static,t38maxval=”MaxBit 0x90, FxMaxBuf 0xc8,
FxMaxData 0x48"
prov-add:name=sys_config_static,t38options="FxFillBit 0, FxTransMMR 0,
FxTransJBIG 0, FxRate Trans, FxUdpEC Red"
illustrates the Hosted UCS- specific static configuration settings
required to support DTMF.
Example 2-11 DTMF support
prov-add:name=sys_config_static, dtmfsupporteddirection=both
prov-add:name=sys_config_static, dtmfsupportedtype=dtmf
illustrates the static configuration settings required to support
transit of the redirecting number parameter.
Example 2-12 Transit of the redirecting number parameter
This is contained in Cisco Unified CM H.225 setup
messages—nonStandardControl field)
messages—nonStandardControl field)
prov-add:name=sys_config_static, h225pavosupported=enabled
illustrates the static configuration settings required to support
CLIP and CLIR.