DJI Quadcopter RtF incl. GPS, incl. camera Inspire 1 with 2RC 数据表

©

 2014 DJI. All Rights Reserved. 

Aircraft

INSPIRE 1

  User Manual

  Aircraft cannot avoid obstruction during the Failsafe RTH, therefore it is important to set an 

reasonable Failsafe altitude before each flight. Launch the DJI Pilot app and enter “Camera” 

view and select “MODE” to set the Failsafe altitude. 

 Aircraft will stop ascending and immediately return to the Home Point if you move the throttle 

stick during the Failsafe.

Failsafe RTH

Failsafe RTH is activated automatically if remote controller signal (including video relay signal) is lost for 

more than 3 seconds provided that Home Point has been successfully recorded and compass is working 

normally. Return home process may be interrupted and the operator can regain control over the aircraft if 

a remote controller signal is resumed.

Failsafe Illustration 

 When the critical battery level warning activates and the aircraft is descending to land 

automatically, you may push the throttle upward to hover the aircraft and navigate it to a more 

appropriate location for landing.

 Color zones and markers on the battery level indicator reflect estimated remaining flight time 

and are adjusted automatically, according to the aircraft’s current status.

GPS

Dynamic Home Point

Dynamic home point is useful in situations when you are in motion and require a Home Point that is 

different from the takeoff point. GPS module is located at the position shown in the figure below:

Ensure the space above the GPS module is not obstructed when using Dynamic Home Point. 

 5 Go Home(20m can be set)

Fast Blinking Yellow

 1 Record Home Point (HP)

 Blinking Green

 3 Remote Controller Signal Lost

Fast Blinking Yellow

 2 Confirm Home Point

Blinking Green

 6 Landing after Hovering 15secs

Fast Blinking Yellow

 4 Signal Lost Lasts 3secs.

Fast Blinking Yellow

Height over HP>20m

Elevate to 20m

Height over HP<=20m

20m

<8m