DJI Quadcopter RtF incl. GPS, incl. camera Inspire 1 with 2RC 数据表

©

 2014 DJI. All Rights Reserved. 

Aircraft

INSPIRE 1

  User Manual

Follow the steps below to use Vision Positioning:

1. Toggle the switch to “P” as shown the figure to the right:

2.  Place the Inspire 1 on a flat surface. Notice that the Vision Positioning system 

cannot work properly on surfaces without pattern variations. 

3.  Power on the Inspire 1. The aircraft status indicator will flash twice in green light, 

which indicates the Vision Positioning system is ready. Gently push the throttle up 

to lift off, and the Inspire 1 will hover in place.

The performance of your Inspire 1’s Vision Positioning System is subject to the surface you are 

flying over. The ultrasonic waves may not be able to accurately measure the distance over sound 

absorbing materials, and the camera may not function correctly in suboptimal environments. The 

aircraft will switch from “P” mode to “A” mode automatically if both GPS and Vision Positioning 

System are not available. So operate the aircraft cautiously when in any of the following situations: 

  Flying over monochrome surfaces (e.g. pure black, pure white, pure red, pure green).

  Flying over a highly reflective surfaces. 

  Flying at high speeds(over 8m/s at 2 meters or over 4m/s at 1 meter).

  Flying over water or transparent surfaces.

  Flying over moving surfaces or objects.

  Flying in an area where the lighting changes frequently or drastically. 

  Flying over extremely dark (lux < 10) or bright (lux > 10,000) surfaces. 

  Flying over surfaces that can absorb sound waves (e.g. thick carpet). 

  Flying over surfaces without clear patterns or texture. 

  Flying over surfaces with identical repeating patterns or textures (e.g. tiles with same design). 

  Flying over inclined surfaces that will deflect sound waves away from the aircraft.

  In the event of loss of remote controller’s signal, the aircraft will hover for 8 seconds and then 

auto-land if it is in “P” mode. 

  Keep the sensors clean at all times. Dirt or other debris may adversely affect the effectiveness 

of the sensors.

  The effective hovering altitudes of the aircraft is from 0 to 2.5 meters. 

  Vision Positioning system may not function properly when the aircraft is flying over water.

 Vision Positioning system may not be able to recognize pattern on the ground in low light 

conditions (less than 100lux).

  Do not use other ultrasonic devices with frequency of 40 KHz when Vision Positioning system is 

in operation. 

 Vision Positioning system may not be able to stabilize the aircraft when flying close to the 

ground (below 0.5 meters) in fast speed.

Keep the animals away from the aircraft when Vision Positioning system is activated. The sonar 

sensor emits high frequency sound that is only audible to some animals.

Flight Recorder 

Flight data is automatically recorded to the SD card. This includes flight duration, orientation, distance, 

aircraft status information, speed, and other parameters. 

Attaching and Detaching the Propellers 

Use only DJI approved propellers with your Inspire 1. The grey or black nut on the propeller indicates 

the rotation direction of the propeller and where it should be attached. To attach the propellers properly, 

match the nut with the dots on the motors of your Inspire 1: