Olimex Web server TCP-IP development board PIC microcontrollers with UEXT connector PIC-WEB PIC-WEB 用户手册
产品代码
PIC-WEB
ELECTROSTATIC WARNING
The PIC-WEB board is shipped in protective anti-static packaging. The board must not be
subject to high electrostatic potentials. General practice for working with static sensitive
devices should be applied when working with this board.
subject to high electrostatic potentials. General practice for working with static sensitive
devices should be applied when working with this board.
BOARD USE REQUIREMENTS
Cables: Depends on the used programming/debugging tool. It could be 1.8 meter USB A-B
cable to connect
cable to connect
to USB host on PC or Serial
or other programming/debugging tools. You will
need a serial cable if not for programming, than for configuring the board. You will also
need a Crossover Ethernet cable.
need a Crossover Ethernet cable.
Note: PIC-KIT3 is recommended for new designs since PIC-ICD2 programmers are not
supported in Microchip's MPLAB X IDE. If you don't mind using MPLAB 8.xx then PIC-
ICD2 is also a good choice.
supported in Microchip's MPLAB X IDE. If you don't mind using MPLAB 8.xx then PIC-
ICD2 is also a good choice.
Hardware: Programmer/Debugger – most of Olimex programmers are applicable, for
example PIC-ICD2, PIC-ICD2-POCKET, PIC-ICD2-TINY, PIC-Kit3 or other
compatible programming/debugging tool.
example PIC-ICD2, PIC-ICD2-POCKET, PIC-ICD2-TINY, PIC-Kit3 or other
compatible programming/debugging tool.
connector.
!!!Warning!!! When you want to program this microcontroller with PIC-ICD2, PIC-ICD2-
POCKET or PIC-ICD2-TINY, before connecting the programmer to your target board, you
should first connect the programmer to your computer and open MPLAB. There, first from
menu Configure – Select Device – choose the microcontroller you are about to program,
then from menu Programmer – Select Programmer – choose MPLAB ICD 2, wait while
MPLAB is downloading operation system, and after ICD2 is connected – check in menu
Programmer – Settings – Power – there is option – Power target circuit from MPLAB ICD 2
– this option should be forbidden, you could not select it. Now it is safe to connect the
programmer to your target board.
POCKET or PIC-ICD2-TINY, before connecting the programmer to your target board, you
should first connect the programmer to your computer and open MPLAB. There, first from
menu Configure – Select Device – choose the microcontroller you are about to program,
then from menu Programmer – Select Programmer – choose MPLAB ICD 2, wait while
MPLAB is downloading operation system, and after ICD2 is connected – check in menu
Programmer – Settings – Power – there is option – Power target circuit from MPLAB ICD 2
– this option should be forbidden, you could not select it. Now it is safe to connect the
programmer to your target board.
Software: PIC-WEB is tested with MPLAB IDE v.8.92 + C18 compiler 3.44 Free
Standart EVAL Version. The latest modified stack version we tested the board with is
TCP/IP stack 5.42 (
Standart EVAL Version. The latest modified stack version we tested the board with is
TCP/IP stack 5.42 (
). It is possible that the stack might not function
properly if used with later versions of MPLAB IDE. You will also need a terminal program
configured at 19 200 bps, 8N1 and XON/XOFF flow control (it's described below).
configured at 19 200 bps, 8N1 and XON/XOFF flow control (it's described below).
Page 3 of 36