Datalogic PowerScan PD9500 PD9530-HPK1 数据表
产品代码
PD9530-HPK1
Enter/Exit Programming Mode
260
PowerScan™ PD9530/PBT9500/PM9500
ADDITIONAL FEATURES FOR 16-KEY MODELS
Last Code Shown Timeout
After the CODE transmission, the last code read will be shown on the display
for a configurable timeout (LAST CODE SHOWN TOUT).
The standard DISPLAY OFF TIMEOUT (see
) has a higher pri-
ority than the LAST CODE SHOWN TOUT, so the two parameters should
be combined to get the desired result.
be combined to get the desired result.
.
$CDIST
Last Code Shown Timeout
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 2 digits (00-63 by 01) from the Alphanu-
meric characters in
GRAMMING MODE bar code above, then the bar code at
left followed by 2 digits (00-63 by 01) from the Alphanu-
meric characters in
End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
not save the entry string. You can then start again at the
beginning.
~
CANCEL
Display Time Stamping Mode
Time Stamping Mode can be applied when entering data from either a bar-
code, from the keyboard, or both.
$CDITS00\r
Applied to both
DEFAULT
$CDITS01\r
Applied only to barcode data
$CDITS02\r
Applied only to keyboard data