Datalogic PowerScan PD9500 PD9530-HPK1 数据表

Enter/Exit Programming Mode

Product Reference Guide

                           267

This function enables/disables the capability to use the SHIFT key to switch 

to Lower Case (alphanumeric) mode. When enabled, the indication in the 

upper right corner of display is ‘ab’. 

$CPWSA00\r

Disable Lower Case

DEFAULT

$CPWSA01\r

Enable Lower Case

This item allows the user to change the default mnemonic label associated 

to each individual function key. This is done by programming a short acro-

nym 4-character string to be shown in the bottom of the display. The pur-

pose of the label is to serve as an indication of the programmed function of 

the Function Key below it. 

$CPWSB

Set F1 label

To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at 
left followed by 8 digits from the 

. The digits must be the hexadecimal ASCII represen-

tation of the desired characters. 

End by scanning the ENTER/EXIT bar code again.

This item allows the user to change the default mnemonic label associated 

to each individual function key. This is done by programming a short acro-

nym 4-character string to be shown in the bottom of the display. The pur-

pose of the label is to serve as an indication of the programmed function of 

the Function Key below it. 

$CPWSC

Set F2 label

To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at 
left followed by 8 digits from the 

. The digits must be the hexadecimal ASCII represen-

tation of the desired characters. 

End by scanning the ENTER/EXIT bar code again.