Renkforce HIFI SYSTEM,CD-2000ME(CD PLAYE 29265c3 数据表

Open the battery compartment on the rear of the IR remote control and insert two type AAA/Micro batteries 

with correct polarity (observe plus/+ and minus/-). Close the battery compartment again.

  If the range of the IR remote control reduces or the CD player no longer reacts to the control 

commands of the IR remote control, replace the batteries by new ones.

 

Observe that some buttons of the IR remote control are not used for the CD player but for other 

devices of the same manufacturer (e.g. an amplifier).

  Before connecting the device, ensure that the mains plug is disconnected. Also disconnect all 

other devices to be connected from their power supply.

  For the connection of the cinch sockets only use the shielded cinch wires. Use of any other cab-

les may cause interferences.

 

To avoid distortions or mal-adjustments that may cause damage to the device, only such devices 

must be connected to the cinch sockets that also have cinch connections (only line levels admis-

sible).

Connect the cinch sockets „LINE OUT“ on the rear of the CD player to the CD input of your amplifier (marked, 

e.g., with „CD IN“ or „AUX IN“). For this, use, e.g., the enclosed stereo cinch cable.
White cinch socket (marked with „L“): Left stereo audio signal
Red cinch socket (marked with „R“): Right stereo audio signal

  Observe that the audio connections are connected in the correct direction so that the audio will 

later be played back in the correct direction as well.

 

Never connect the CD player to the phono input of the amplifier. It is only suitable for record 

players.

The CD player has a socket for digital audio transmission on its back (labelled „OPTICAL“). The audio signal 

here is transmitted by light. 
Connect the corresponding socket of the CD player to the optical input of your amplifier using a suitable 

cable.