Spektrum DX6i SPMR6630 用户手册

SPEKTRUM DX6i • RADIO INSTRUCTION MANUAL

The Contrast function adjusts the image on the LCD for visibility 
in sunlight. The default value is 50%.

A  Option value (0-100%)

CONTRAST

50%

List

A

The Copy/Reset function supports copying the active model memory 
to any of the other 9 available model memories. This is useful for 
setting up a model with different programming or to set up a similar 
model. 

 Option value (1-10, except for active model)

 Approval to delete destination model memory information 

CAUTION: Model information saved in a memory is erased 
when that model memory is copied over or reset to factory 
default settings. 

The RESET function removes all model programming from the cur-
rent model memory.

 Approval to delete model memory information, overwriting 

memory with factory default settings. 

NOTICE: If your DX6i was included in an RTF kit, factory default 
settings will include programming. Using the RESET function will 
erase this programming.

COPY/RESET

MODEL 6  MUSTANG

COPY 

RESET

List

A

COPY/RESET

MODEL 6  MUSTANG

COPY  TO   1

SURE?  NO/YES

List

A

B

Model Select function opens a model memory for control of a 
model or adjustment of saved settings. If you haven’t pro-
grammed a model memory, all settings will be at factory default. 

CAUTION: Do NOT change the model in Model Select 
while operating a model. Change of the model interrupts 
transmitter signal to a receiver and may cause a crash. 

A  Model memory number
B  Model name

MODEL SELECT

MODEL    6

MUSTANG

List

A

B

The Dual Rate and Exponential function supports programming 
of 2 control rates. Dual Rates and Expos are available for aileron, 
elevator and rudder channels. Changing Dual Rate value affects 
maximum control authority and sensitivity of control. Increasing 
the rate increases sensitivity of the controls. Changing Expo-
nential value affects sensitivity around center (neutral). You can 
control Dual and Expo rates by respective D/R switches (aileron, 
elevator and rudder) or by one common switch (Aileron D/R, El-
evator D/R, Rudder D/R or the Gear switch. See COMBI SWITCH 
screen for combining D/R switches to one common switch).
You can adjust dual rate values from 0–100%. Factory default 
settings are 100% for switch positions 0 and 1. 

Note: Refer to your model’s manual for recommended rate 
settings. 

Exponential values are adjustable from -100% to +100%. The 
factory default setting is 0% or INH (inhibit).

You can change either switch position to low or high rate by 
putting the switch in the desired position and adjusting its value 
in the D/R & EXPO screen.

A  D/R switch position (0=low, 1=high)
B  Exponential rate setting (-100 to 100%, with INH at 0)
C  Rate setting (0 to 100%)

Note: A negative (-) Expo value increases sensitivity around  
neutral, and a positive (+) Expo value decreases sensitivity 
around neutral. A positive value usually desensitizes control 
response around neutral.

D/R&EXPO

AILE  1  100%    INH%

ELEV  1  100%    INH%

RUDD  1  100%    INH%

List

C

A

B