Beck, R&J ELECTRIC ACTUATORS FOR INDUSTRIAL PROCESSCONTROL 11-1_9 用户手册
17
INSTALLATION
SIGNAL WIRING
Each Beck drive is custom built to match the
control requirements of your system specified
at the time of order. Each drive has a specific
wiring diagram attached to the inside of the wiring
terminal cover. Typical wiring connections are
described below.
at the time of order. Each drive has a specific
wiring diagram attached to the inside of the wiring
terminal cover. Typical wiring connections are
described below.
A drive can be ordered with up to four optional
auxiliary switches. Wiring connections for these
are described on page 26.
are described on page 26.
To prevent Handswitch initiated motion,
remove the jumper between terminals A and C.
CAUTION: AC power to the drive must be
turned off before removing the jumper.
CAUTION: AC power to the drive must be
turned off before removing the jumper.
Typical Wiring Connections
POWER AND DEMAND
INPUT CONNECTIONS
Customer must supply 120 V ac to power the
drive and control circuitry. 120 V ac line connects
to terminal C and neutral to terminal B. Input signal
wires connect to terminals AA (+) and BB (–).
to terminal C and neutral to terminal B. Input signal
wires connect to terminals AA (+) and BB (–).