Ez Access Mobility Aid ez-access 用户手册

- 10 - 

E) 

 

i) 

Slip the base foot under each support tube (FIG. 11). 

If installing on soft soil it may be necessary to set the base foot on 

a concrete pad or stepping stone. 

ii) 

Adjust the final height of the platform. 

a. 

Adjust each leg one at a time by loosening the bolt in the platform 
saddle bracket. Using a level, adjust the platform height and 
retighten (FIG. 12).  

iii) 

Once the final height has been adjusted, tighten the second bolt in each 
platform saddle bracket. 

iv) 

Ensure that all bolts are secure. 

 

 

 

F) 

 

i) 

Install platform brace assemblies on all support tubes when the walking 
surface is 36” or more above the ground. The platform brace assemblies 
are normally installed on all four sides (FIG. 13). 

ii) 

Platform brace assemblies need to be cut to desired length and 5/16” holes 
to attach the brace bands will need to be drilled at both cut ends. 

iii) 

Ensure that all platform brace assemblies are secured before using 
platform. 

 

 

- 23 - 

v) 

Cut round tube to the length measured (FIG. 31). 

vi) 

Using a metal file, smooth any sharp edges from the cutting. 

vii) 

Insert cut tube into place and tighten all set screws on ring joiner/adjustable 
elbows assemblies (FIG. 32). 

 If difficult to install, disassemble adjustable elbows and reconfigure. 

10) 

A) 

Some platform configurations will have unused corner pockets on which corner 
pocket protective cap will need to be installed (FIG. 32a).