Ez Access Mobility Aid ez-access 用户手册

- 24 - 

11) 

A) 

This kit will connect the handrails on a platform to the handrails on one side of 
the ramp. 

i) 

 If needed, drop square tube post into corner pocket on platform and 

tighten two set screws with supplied 3/16” allen wrench (FIG. 33). 

ii) 

Using an adjustable elbow with a threaded insert in one end, pass 5/16” x 

2” buttonhead screw through the hole in square tube into threaded insert on 
adjustable elbow. Tighten lightly (FIG. 34). 

iii) 

Insert ring joiner into each end of other elbows (FIG. 35). 

iv) 

Insert ring joiner/adjustable elbow assembly into tube end on ramp handrail 

and position both assemblies until they are aligned (FIG. 36). 

v) 

Measure the distance between the ring portions of the ring joiner 

assemblies. HELPFUL HINT: Use the supplied 5/32” and 3/16” allen 
wrenches to lightly tighten the ring joiner/adjustable elbow assembly so they 
hold their position while measuring. 

vi) 

Cut round tube to the length measured (FIG. 37). 

vii) 

Using a metal file, smooth any sharp edges from the cutting. 

viii) 

Insert cut tube into place and tighten all setscrews on ring joiners and 

adjustable elbows (FIG 38). 
NOTE:

  If difficult to install, disassemble adjustable elbows. 

 

 

 

 

 

- 9 - 

D) 

 

i) 

Tip the platform on its side. Have one person support the platform while the 
other person slides the support tubes into the platform saddle brackets. 
Adjust the support tubes to the approximate height needed (FIG. 10). 

 

 

 

 

ii) 

Using a 9/16” socket wrench, secure each of the support tubes with one of 
the two bolts on each platform saddle bracket (the second bolt will be 
tightened after final height adjustments are complete). The universal 
platform configured as a turn back platform (FIG. 3) will have eight tubes to 
adjust. 

Do not attempt to walk on the platform without both bolts in 

each platform saddle bracket tightened securely. 

iii) 

Place the platform with support tubes attached into the upright position. 
IMPORTANT

: Do not let the weight of the platform bear on the support 

tubes while tipping the platform upright as it may bend the outer rail.