Black & Decker Trimmer LPHT120B 用户手册

The standard charger provided will charge a fully depeleted battery 

in about 4 hours. 

1. Plug the charger into an appropriate outlet before inserting the 

battery pack.

2. Insert the battery pack into the 

charger as shown in figure 1. 

 3. The green LED will flash 

indicating that the battery is being 

charged.

 4. The completion of charge 

is indicated by the green LED 

remaining on continuously. The 

pack is fully charged and may 

be used at this time or left on the 

charger.

battery life may be greatly diminished. It is recommended that the 

batteries be recharged after each use.
IMporTANT CHArgINg NoTeS

1. Longest life and best performance can be obtained if the battery 

pack is charged when the air temperature is between 60°F and 80°F 

(16°- 27°C). DO NOT charge the battery pack in an air temperature 

below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important 

and will prevent serious damage to the battery pack.

2. The charger and battery pack may become warm to touch 

while charging. This is a normal condition, and does not indicate a 

problem. To facilitate the cooling of the battery pack after use, avoid 

placing the charger or battery pack in a warm environment such as 

in a metal shed, or an uninsulated trailer.

3. If the battery pack does not charge properly:

 

a. Check current at receptacle by plugging in a lamp or other  

 appliance

 

b. Check to see if receptacle is connected to a light switch  

 

which turns power off  when you turn out the lights. 

 

c. Move charger and battery pack to a location where the   

 

surrounding air temperature is approximately 60°F and 80°F  

 

(16°- 27°C)

 

d. If charging problems persist, take the tool, battery pack and  

 

charger to your local service center.

4. The battery pack should be recharged when it fails to produce 

sufficient power on jobs which were easily done previously. 

DO NOT CONTINUE to use under these conditions. Follow the 

charging procedure. You may also charge a partially used pack 

whenever you desire with no adverse affect on the battery pack.

5. Foreign materials of a conductive nature such as, but not limited 

to, steel wool, aluminum foil, or any buildup of metallic particles 

should be kept away from charger cavities. Always unplug the 

charger from the power supply when there is no battery pack in the 

cavity. Unplug charger before attempting to clean.

6. Do not freeze or immerse charger in water or any other liquid.

Shock hazard. Do not allow any liquid to get 

inside charger. Never attempt to open the battery pack for any