Canon DP-V3010 说明手册
78
Error Messages
Error Messages
Message
Description and Action
Calibration
Failed to initialize the external sensor.
See CA-310 and CA-210 instruction manual.
Calibration error.
• Check the installation and connection of the
external sensor and retry (
• Perform matrix calibration of CA-310 and CA-210
(
Calibration is completed.
(Brightness setting is lower than target brightness.)
(Brightness setting is lower than target brightness.)
Set the "Luminance" in calibration again (
Failed to detect the external sensor.
Please check the connection of the sensor.
Please check the connection of the sensor.
Correctly connect the external sensor to the USB
port of this main unit.
port of this main unit.
Network
Communication error.
IP address may be in conflict or there may be a
network communication error. Check the network
environment.
network communication error. Check the network
environment.
Invalid IP Address.
Enter the correct IP address.
Invalid Subnet Mask.
Enter the correct subnet mask.
Various settings,
CDL export
CDL export
There is no capacity USB memory.
Use another USB memory or delete the content of
the memory.
the memory.
Failed to write file.
The USB memory may be defective or protected.
Check the USB memory.
Check the USB memory.
(CDL Export) Number of files is over limit.
Up to 1000 files can be exported.
LUT, Various settings,
CDL import
CDL import
(LUT Import) "LUT Type" is different.
(CDL Import) "File Type" is different.
(CDL Import) "File Type" is different.
Select the correct file format.
Failed to read file.
The USB memory may be defective or protected.
Check the USB memory.
Check the USB memory.
Failed to Import.
There is an error in the file to be imported. Check the
file.
file.
No import file.
Check to see if the file has been imported to the
USB memory.
USB memory.
Hardware error
Backlight error.
Turn off the main power once and then back on.
If the message persists, contact Canon Customer
Center.
If the message persists, contact Canon Customer
Center.
Fan error.
Panel error.
I/F error.
System error.
Input signal
No Signal
Displayed when there is no video signal input.
Unsupported
Unsupported video signal is input. Check the
supported signal format (
supported signal format (
"Input Configuration" is different from Payload.
Check the "Input Configuration" (
40) and "Signal
Information" (
53) settings. Reset any incorrect
"Input Configuration" settings.
COP
Y