Dacor ERV3615 安装指导

2.  Cut and remove the foil material inside the knock-out 

hole. If you fail to remove the foil, the vent will not work.

3.  If the unit will vent through the bottom or side:

•  Attach the supplied ATD2 transition to exhaust 

location with the provided sheet metal screws.

•  For bottom installations cut a hole in the cabinet 

floor to allow the exhaust transition and/or the duct 

to pass through the floor.

4.  If the unit will exhaust air from the back, attach a  

3 ¼” X 10 duct to the vent hole created by removing 

the knock-out on the back of the unit.

Installation Instructions

Back of unit

Side 

knock-out

Side 

knock-out

Bottom knock-out

Rear knock-out with 

metal cross overs 

shown

ADT2 side 

installation

ADT2 bottom 

installation

Attach sealing 

foam

Floor

Cut hole in floor to allow 

duct to pass through on 

bottom venting installations

Top of vent resting 

on countertop

Installation Preparation

Verify Package Contents

•  Product literature
•  Anchoring legs
•  2 wood screws, #14 x 2 ½ (PN 83047) 
•  3 wire nuts
•  ADT2 duct transition
•  2 sheet metal screws, #10 x ½ (PN 83022)
•  2 keps nuts, ¼-20 (PN 83049)
•  2 flat washers, ¼-20 (PN 83203) 
•  Insulation foam

Installation

•  If the electrical service (electrical outlet) does not meet 

the Electrical Specifications on page 4, do not 

proceed with the installation. Call a licensed electrician 

and have an electrical outlet installed that meets the 

specifications.

•  Install the vent only in a vertical orientation. Do not 

mount the vent on a slant or angle.

•  Do not enlarge or modify the exhaust knock outs or 

cut an exhaust hole in a location on the chassis other 

than those shown. Doing so may cause an increase in 

noise and decrease performance.

NOTE: The raised vent installs in the back of the cutout, 

separate from the cooking appliance. Install the raised vent 

before installing the cooking appliance.

Installing the Raised Vent

1.  Remove the appropriate side, back or bottom exhaust 

knockout, depending on the desired exhaust configura-

tion, from the raised vent chassis by cutting the metal 

cross overs and removing the insert.