Dacor ERV3615 安装指导

Installation Instructions

Ground

Power Input

Blower Output

Electrical access 

panel

To power wiring/conduit.

Connect other end of 

wires to blower terminal 

block.

Wires to power plug. 

Pre-wired at factory. 

Do not modify.

Attach ground wire 

as shown

Match wire colors to 

terminals as shown.

BLACK

WHITE

GREEN

Electrical Installation

•

ELECTRIC SHOCK HAZARD - Do not connect the 

raised vent power plug to the electrical outlet until 

installation is complete.

•  Failure to complete electrical connections properly 

may result in an electric shock hazard or a damaged 

or non-functional system. Follow the wiring diagrams 

carefully to ensure a proper installation. Do not 

change the factory wired terminal connections inside 

the electrical access panel for the raised vent or the 

blower.

•  To avoid an electric shock hazard and to prevent dam-

age route all wiring away from hot surfaces.

1.  Run the wiring/conduit line used to supply power from 

the raised vent to the blower parallel to the duct work.

2.  Make sure the raised vent power plug is disconnected 

from the electrical outlet.

3.  Remove the cover from the raised vent electrical 

access panel. 

4.  Connect the wiring/conduit to the blower according to 

the wiring diagrams on this page, the facing page and 

local codes and ordinances. Make sure all terminal 

connections, including the factory wired connections, 

are tight.

5.  Replace the electrical access panel.