Elica ERS63XSS 安装指导

5.  Drill 2 pilot holes through each of the undercounter mounting 

 

brackets into the underside of the countertop. Using 2 screws 

 

(not provided) of the appropriate length, mount the brackets to 

 

the countertop. 

IMPORTANT: Select a screw length that will not allow the screws to 

go through the countertop when tightened. 

6.  Check that the downdraft vent is level vertically. Loosen the lower 

 

support legs screws and position the legs against the cabinet 

 

floor.

7.  Fasten the lower support legs to the cabinet floor with screws 

 

(not provided). 

8.  Tighten the lower support legs screws.

•

Before the control installation, make sure you have made the 

 

cutouts to proceed (see “Countertop Dimensions Chart”).

•

Place the control base on location and mark the holes with a 

 

pencil. Put the base aside.

•

Drive the installation screws on the marked points. Once you 

 

have inserted the screws, remove them.

•

Place the control base in place and drive the installation screws 

 again.

•

Run the control cable through the countertop hole.

•

Push down the control assembly against the control base, until 

 

you hear the click. 

Failure to do so can result in death or electrical shock. 

1.  Disconnect power.

2.  Feed the power supply cable through the conduit connector 

 

and into the terminal box. 

 

WARNING 

3.  Connect the green (or green/yellow) ground wire to the green 

 

or yellow/green ground wire using UL listed wire connectors.

4.  Tighten the screw on the conduit connector.

5.  Connect the 2 white wires together using UL listed wire 

 connectors.