Elica ERS63XSS 安装指导

NOTE: The downdraft vent system is supplied with a 3

1

⁄

4

” x 10” 

(8.3 x 25.4 cm) rectangular vent transition and a 6” (15.2 cm) round 

vent transition with damper. Refer to “3

1

⁄

4

” x 10” (8.3 x 25.4 cm) back

draft damper” or “6” (15.2 cm) round vent transition with

damper,” depending upon the type of venting you are using. 

1.  Attach the 3¼” x 10” (8.3 x 25.4 cm) back draft damper to the 

 

vent opening in the blower motor box, using three 3.5 x 9.5 mm 

 screws. 

 

1.  Attach the 6” (15.2 cm) round vent transition to vent opening 

 

(left or right side venting only is recommended), using two  

 

3.5 x 9.5 mm screws. 

2.  Remove 4 screws attaching the terminal box cover.

3.  Determine which direction (front or rear) the home power supply 

 

cable will enter the terminal box. Remove the appropriate  

 

knockout from the front or rear panel and install a ½” (12.7 mm) 

 

UL listed or CSA approved conduit connector. 

4.  Using 2 or more people, insert the downdraft vent into the  

 

countertop cutout. Position downdraft vent so it is centered in the  

 

cutout with the rear flange over the edge of the cutout and the   

 

rear of the vent box against the edge of the cutout.