Baby Trend E30FL0211U 用户手册

8. A lap/shoulder combination seat belt with 

buckle that can slide freely along the seat 

belt may require the use of a locking clip.  

(Fig. 42-2)  Check your vehicle’s owner’s 

manual to see if the vehicle manufacturer 

has provided an alternate manner, such 

as a locking retractor in which to prevent 

movement of the lap portion of the seat belt.   
• To install the locking clip, tighten the 

buckled seat belt by pulling upward on 

the shoulder portion of the seat belt  

while pushing down hard on the Safety 

Seat or Base.  

• While maintaining downward pressure 

on the Safety Seat or Base, squeeze the 

shoulder belt and lap belt together just 

above the buckle to prevent from moving.  

Unbuckle the seat belt being careful to 

prevent movement of the buckle.

• Secure the shoulder belt to the lap belt 

by installing the locking clip 1/2 inch from 

the buckle as shown in Fig. 42-3.  

• Re-buckle the seat belt and check that 

the seat belt is very tight around the 

Safety Seat or Base.  Pull on the lap belt 

to ensure that the locking clip is locking 

the lap belt and it remains very tight.

Fig. 42-1

Fig. 42-2

Fig. 42-3

9. If you are using the Base, check that 

nothing is on top of the base, or anything 

that will interfere with the proper latching 

of the Safety Seat to the Base.  Place 

the Safety Seat onto the Base and 

push down until the Safety Seat latches 

securely to the Base and you hear a 

click.  Pull upward on the Safety Seat to 

check that the Safety Seat is securely 

latched onto the base. (Fig. 43-1)

If the Safety Seat does not securely latch onto the Base, the 

Safety Seat will NOT provide Protection for your child.  

DO NOT 

use the Safety Seat with the Base if it does not securely latch into 

place.  Please call Baby Trend at 1-800-328-7363 for assistance.

Lower Anchors and Tethers for Children (

LATCH) System is 

designed to make installation of child safety seats easier by 

requiring child safety seats to be installed without using the 

vehicle’s seat belt system. By September 1, 2002, two rear seating 

positions of all cars, mini vans and light trucks will come equipped 

with lower child safety seat anchor points located between a 

vehicle’s seat cushion and seat back. Also by September 1, 2002, 

all child safety seats will have two attachments which will connect 

to the vehicle’s lower anchor points.  Together, the lower anchors 

and upper tethers make up the 

LATCH system.  Rear-facing infant 

seats do not make use of the upper tether.

Fig. 43-1