Sanyo DSR-3506P 用户手册
RECORDING
3
20
English
OPE
RATIO
N
Use the following procedure to automatically record alarm
video to the alarm recording area when an alarm signal is
detected.
Recording will not be possible until a time has been set for
the digital video recorder. Make sure to set the time. (JP.14)
video to the alarm recording area when an alarm signal is
detected.
Recording will not be possible until a time has been set for
the digital video recorder. Make sure to set the time. (JP.14)
1
Set alarm recording.
Follow the instructions on P.68 set “7. ALARM REC MODE
SET” from <RECORD SET>.
SET” from <RECORD SET>.
2
Press the [EXIT] button.
The setting procedure is ended and the normal screen is
displayed.
displayed.
z
When an alarm signal is detected, “ALARM” flashes in
the operation display and the alarm recording starts
(indicated by “REC”).
the operation display and the alarm recording starts
(indicated by “REC”).
z
Alarm video is recorded to the alarm recording area.
z
Whenever an alarm occurs, the number of alarms as
indicated in the operation display is incremented.
indicated in the operation display is incremented.
z
If an alarm occurs during normal recording or timer
recording, the recording operation will be ended.
recording, the recording operation will be ended.
z
A maximum of 16,000 alarm recordings can be made
on one hard disk. If hard disk expansion is carried out,
this number can be increased to 32,000. Note,
however, since settings for each condition will affect the
maximum number of recordings that can be made, be
sure to check menu settings and display content.
on one hard disk. If hard disk expansion is carried out,
this number can be increased to 32,000. Note,
however, since settings for each condition will affect the
maximum number of recordings that can be made, be
sure to check menu settings and display content.
3
End alarm recording.
When the alarm duration has expired (default setting: 20
seconds), both “REC” and “ALARM” finish flashing from
the operation display and recording stops.
seconds), both “REC” and “ALARM” finish flashing from
the operation display and recording stops.
z
When the space remaining in the alarm recording area
drops below a preset value, the FULL indicator on the
digital video recorder’s front panel starts to flash. If
recording is continued beyond this point, the alarm
recording area will become full, recording will stop, and
the FULL indicator will stop flashing and remain lit. In
such a case, use the <RECORDING AREA SET> menu
to perform “AREA FULL RESET” for the alarm
recording area, thus allowing recording to start again
from the beginning. (JP.60)
drops below a preset value, the FULL indicator on the
digital video recorder’s front panel starts to flash. If
recording is continued beyond this point, the alarm
recording area will become full, recording will stop, and
the FULL indicator will stop flashing and remain lit. In
such a case, use the <RECORDING AREA SET> menu
to perform “AREA FULL RESET” for the alarm
recording area, thus allowing recording to start again
from the beginning. (JP.60)
[EXIT] button
ALARM FULL indicator
POWER indicator
[REC/STOP] button
[TIMER] button
Alarm recording
EXIT
When an alarm signal is detected
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
02
Counts the number
of alarms.
Values between
0000 and 9999 can
be displayed.
e00_l8hbe_xe_7.book Page 20 Tuesday, April 27, 2004 10:35 AM