DISH Network Solo 351 用户指南

9. If your TV is in off-air mode for the channels you picked in step 7, write 

“Air” in the blank provided in the margin. If your TV is in cable mode 

for the channels you picked in step 8, write “Cable” in the blank 

provided in the margin.

10. Set all of your remote TV(s) to the channel mode (Off-Air or Cable) 

you wrote in the margin.

11. Tune all of your remote TV(s) to the channel you wrote in the margin. 

This is the channel you will use to receive your satellite programming.

12. Turn on the nearby TV (the TV that gets programming from the TV1 

outputs).

13. Press the POWER button on Remote Control 1 to turn on the receiver's 

green TV1 indicator.

14. You should now be looking at the 

 screen on your nearby 

TV. Select the 

, if shown. If the option is not shown, 

press MENU 6-1-5 on Remote Control 1 to get to the 

 

screen.

15. With the 

 screen displayed on the nearby TV, use 

Remote Control 1 to do the following:
a. Under 

, select either 

 (for off-air channel numbers) or 

 (for cable channel numbers) based on what you wrote down in 

the margin in step 9.

b. Under 

, use the up and down arrow buttons to change the 

modulator channel to the one you wrote in the margin in step 8. 

c. Select 

 to save the changes.

16. Using Remote Control 2, press the POWER button and make sure the 

receiver's blue TV2 indicator turns on.

17. For some TVs, you must run a channel scan so that the TVs will find 

and display the selected channel from the receiver. Run channel scan on 

all remote TV(s), if available. See your TV user guide for instructions.

18.

C

onfirm that you see a picture from the receiver TV2 output, likely the 

Point Dish screen, on your remote TV(s).
•

If your picture looks good, go to step 26. 

•

If your TV(s) do not have a picture or if it is not as clear as you 

would like it to be, go to the next step.