DISH Network Solo 351 用户指南

19. You may need to change the cable connection on the splitter that sends 

the TV signal throughout your house. The change that needs to be made 

is move the cable coming from the receiver 

 from the 

output of the splitter to the input of the splitter using the instructions 

below.

The following figure shows an example of what your splitter may look 

like. Your splitter may look different. The places where the splitter 

indicates 

 refers to all TVs connected to your cable system. The 

places where the splitter indicates 

 refers to where the signal is fed into 

the splitter.

20. Find where the TV signal is distributed throughout your house. It should 

be near where the cable TV service enters the house.

21. Disconnect the cable TV service cable or antenna cable from the splitter 

input, if necessary. Make sure the disconnected cable is capped or 

otherwise protected from the weather.

22. Disconnect the cable coming from the receiver 

 port from 

the splitter. If you do not know which cable this is, go to the next step. 

Otherwise, go to step 24.

23. If you have multiple TVs on the cable system, do the following to 

determine which cable on the splitter is coming from the receiver:
•

If you have at least some picture on your TV(s), turn on all remote 

TVs connected to the cable system. Disconnect and reconnect each 

cable one by one observing what happens to the TV(s). When all 

remote TVs lose the signal, you have disconnected the receiver’s 

cable. If only some or one TV loses the signal, then you have 

disconnected a cable from the TV(s).

•

If the above step does not work, disconnect one of the output cables 

and connect to the splitter input. If you do not see a picture, connect 

the cable back to its output. Repeat this step on every connection 

until you get a picture on the remote TV(s).

24. Reconnect the receiver’s cable to the input of the splitter.