DISH Network Solo 351 用户指南

1. Connect 

 on the receiver to your existing wall cable outlet 

using a coaxial cable.

: 

If you do not have an existing in-home cable system, you 

will need to run coaxial cable to each TV in other rooms. If this is 

too difficult, you may want to contact a professional to do this 

installation.

2. Place the yellow sticker on the 

 cable near where the cable 

attaches to the receiver. See the tip in the margin.

3. Make sure batteries are installed in Remote Control 2 and the UHF 

antenna is attached to 

 port on the receiver. 

4. Make sure the receiver's blue TV2 indicator is off. If it is on, turn it off 

by doing the following:
a. Press the SAT mode button on Remote Control 2 to put the remote 

control in SAT mode.

b. Press the POWER button on Remote Control 2 and make sure the 

receiver's TV2 blue indicator turns off.

5. Connect the tuner input of the remote TV(s) in other rooms to an 

existing wall cable outlet using a coaxial cable.

6. Turn on every remote TV connected to the in-home cabling system. 
7. Find three channels next to each other on one of your remote TVs that 

do not pick up any signals from off-air or cable broadcasts (they should 

show nothing but snow or static). These channels must fall in one of the 

two ranges below. For example, if you find that cable channels 75, 76, 

and 77 do not pickup any broadcasts, pick these channels since they fall 

into the range below for cable channels. Make sure these three channels 

on other remote TVs also do not pick up broadcasts.
•

 - Select a channel between 21 and 69.

•

 - Select a channel between 73 and 125.

: The remote TV(s) will have to be set to the same channel mode, 

either off-air or cable channel mode for this installation. See your TV 

user guide for instructions on how to set your TV to off-air or cable 

channel modes.

8. Pick the channel in the middle of the three you selected in step 7. Write 

that channel down in the blank provided in the margin. For example, if 

the three channels you picked in the preceding step were cable channels 

75, 76, and 77, pick channel 76 and write it in the margin.

Make sure you are familiar with how to change channels on

your TV and if necessary how to switch your TV between

off-air and cable channels. During this procedure, it will be

necessary to change the channels on your TV(s) to tune to

these channels to see the video from the receiver. See your

TV user guide for instructions.