Motorola RMM2050 用户手册

English

Assuming the current code value is set to 
factory default ‘001’, and you want to change it 
to CTCSS/DPL Code = 103. Follow the 
sequence indicated below:

Enter Advanced Configuration Mode.

Short press the PTT button twice. The radio 

audible voice announced “Code Number” 
(Entering CTCSS/DPL Programming Selection 
Mode).

Pressing and holding SB1 or SB2 button fast 

forwards / rewinds the value at the nearest 10’s. 
When released, the radio audible voice 
announces the first, second and third digit in 
full. Keep pressing the SB1 or SB2 button 
several times until you hear “103”. 

Long press the PTT button. LED Indicator 

shows a green heartbeat to indicate ‘Idle’ 
Programming Mode.

Long press the PTT button again to exit 

Programming Mode or turn OFF the radio.

Auto-Scan is the third available feature in the 
Programming Mode and can be set to either 
ON or OFF on a particular channel.

To set Auto-Scan to ON:

•

Enter Advanced Configuration Mode and select 
the desired channel.

•

Short press the PTT button three times to enter 
the Active Channels Programming Selection 
Mode. The audible voice in the radio announces 
“Auto-Scan” and the setting (Enabled or 
Disabled).

•

To change the setting, press SB1 or SB2.

•

Long press the PTT button. LED Indicator shows 
a green heartbeat to indicate ‘Idle’ Programming 
Mode.

•

Long press the PTT button again to exit 
Programming Mode or turn OFF the radio.