Motorola RMM2050 用户手册

English

which was previously selected before Scan is 
activated. If no transmission occurs within 5 
seconds, scanning resumes.

•

If you want to scan a channel without the 
Interference Eliminator Codes (CTCSS/DPL), set 
the code settings for the channels to ‘0’ in the 
CTCSS/DPL Programming Selection Mode.

Whenever the radio is set to Scan, the LED 
Indicator blinks a Red Heartbeat.

Scan List can be edited by using the CPS. For 
more information refer to “Customer 
Programming Software (CPS)” on page 40.

Nuisance Channel Delete allows you to 
temporarily remove channels from the Scan 
List. This feature is useful when irrelevant 
conversations on a ‘nuisance’ channel ties up 
the radio’s scanning feature.

To delete a channel from the Scan List:

•

Start Scan mode by short pressing the SB1 or 
SB2 (programmed for scan) button.

•

Wait until the radio stops at the channel you wish 
to eliminate. Long press the SB2 button to delete 
it. You cannot delete the channel with scan 
enabled (home channel).

•

The channel will not be scanned again until you 
exit the Scan mode by short pressing the SB1 or 
SB2 (programmed for scan) button again or by 
turning OFF the radio and back ON.