用户手册目录General11.1 Introduction11.2 Firmware Revision11.3 Features11.4 Quick Install12.1 Unpacking the Box22.2 Choosing a Mounting Location22.2.1 Mounting Location When Used With Analog Gauge(s)22.2.2 Mounting Location When Used Without Analog Gauge(s)3Figure 1– Mounting Location When Used with Analog Gauge32.3 Connecting the RAA10042.3.1 Connecting Attached Gray Cable to Analog Gauge or Rudder Sender4Figure 2 – Mounting Location When Used Without Analog Gauge4Figure 3 – RAA100 Connections42.3.1.1 Connecting Attached Gray Cable to Analog Gauge52.3.1.2 Connecting Attached Gray Cable to Rudder Angle Sender52.3.2 Connecting to NMEA 2000® Interface5Table 1 – RAA100 Gauge Connections5Table 2 – RAA100 Resistive Rudder Angle Sender Connections53.1 Configuring Rudder Instance Number6Figure 4 – NMEA 2000® Connector Face Views63.2 Configuring Operating Mode73.2.1 Configuring Analog Gauge Resistance73.2.1.1 Power Terminal to Sensor Terminal Resistance Measurement73.2.1.2 Ground Terminal to Sensor Terminal Resistance Measurement73.3 Standard Sender Selection or Custom Calibration83.3.1 Standard Sender Selection83.3.2 Custom Calibration8Troubleshooting9Figure 5 – Troubleshooting Guide10Technical Support11文件大小: 298.7 KB页数: 17Language: English打开用户手册