ATTO Technology 2700C Benutzerhandbuch

43

 

ATTO Technology Inc. iPBridge Installation and Operation Manual

ATTO iPBridge diagnostic commands help validate iPBridge operation and diagnose/isolate iPBridge 
faults. Event logging is a mechanism for on-site observation of internal iPBridge 2700 behavior such as 
tracing Fibre Channel commands received over the GbE from the host and return of data and status to 
the host. 

BridgeModel
Reports model information about a specific iPBridge

Get syntax: get BridgeModel

BridgeName
Specifies name used to identify individual iPBridge units. 
May be up to a maximum of eight characters. It is not the 
World Wide Name (WWN).

Set syntax: set BridgeName [value]
Requires a SaveConfiguration command
Get syntax: get BridgeName

ClearEventLog
Clears the contents of the event log. No events will be 
recorded until the command has been completed.

Immediate command: ClearEventLog

ClearTraceLog
Clears the contents of the trace log. No events will be 
recorded until the command has been completed.

Immediate command: ClearTraceLog

DisplayEventLog
Displays the most recent page of event log entries. Typing 
a +, - or = causes the next, previous or same page of event 
log entries to be displayed. No events will be recorded 
until the command has been completed. Type <escape> 
to disable the command, begin new log entries, and return 
to CLI.

Immediate command: DisplayEventLog < + | - | =| ESC>

DisplayEventLogFilter
Filters the display of data for specific iPBridge 
subsystems when in DisplayEventLog mode. If enabled 
for a particular subsystem and level, that subsystem and 

Subsystem entries:

................

Log level entries:

.......

FC

.....................................

INFO

.......

ENET

................................

WARN

.......

NVRAM

..............................

CRIT

.......

PERF

.................................

FAIL

..... .

ECC

...................................

ALL

.......

ALL

.......

GEN

.......

HTTP

.......

iSCSI

Default: disabled
Set syntax: set DisplayEventLogFilter [subsystem] [level] 
[enabled|disabled]
Get syntax: get DisplayEventLogFilter [subsystem] [level]

DisplayTraceLog
Displays the most recent page of trace log entries. Typing 
a +, - or = causes the next, previous or same page of trace 
log entries to be displayed. No events will be recorded 
until the command has been completed. Type <escape> 
to disable the command, begin new log entries, and return 
to CLI.

Immediate command: DisplayTraceLog < + | - | = | ESC>

DisplayTraceLogFilter
Filters the display of data for specific iPBridge 
subsystems when in DisplayTraceLog mode. If enabled 
for a particular iPBridge port, that port will be masked 
when the command DisplayTraceLog is issued.

Default: disabled
Set syntax: set DisplayTraceLogFilter [enabled | disabled]
Get syntax: get DisplayTraceLogFilter