Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
Routing Commands
741
M5300, M6100, and M7100 Series ProSAFE Managed Switches
DHCP server messages relayed................... 2
UDP client messages received................... 8
UDP client messages relayed.................... 2
DHCP message hop count exceeded max............ 0
DHCP message with secs field below min......... 0
DHCP message with giaddr set to local address.. 0
Packets with expired TTL....................... 0
Packets that matched a discard entry........... 0
Open Shortest Path First Commands
This section describes the commands you use to view and configure Open Shortest Path
First (OSPF), which is a link-state routing protocol that you use to route traffic within a
network. This section contains the following subsections:
First (OSPF), which is a link-state routing protocol that you use to route traffic within a
network. This section contains the following subsections:
•
•
•
•
•
The following switches support OSPF:
•
M6100
•
M5300-28G3
•
M5300-52G3
•
M5300-28GF3
The following switches support OSPF with an L3 license:
•
M5300-28G
•
M5300-52G
•
M5300-28G-POE+
•
M5300-52G-POE+
General OSPF Commands
router ospf
Use this command to enter Router OSPF mode.
Format
router ospf
Mode
Global Config