Trane Gas Unit Heaters Wartungshandbuch
Start-Up
GTND-SVX01B-EN
43
Gas Equipment Start-Up
Customer _____________________________________________
Job Name & Number _________________________
Pre-Inspection Information with Power and Gas Off
Type of Equip:
Unit Heater
Serial Number: _________________________
Model Number: _____________________________
Name Plate Voltage: ____________________
Name Plate Amperage: ______________________
Type of Gas:
Natural
LP
Tank Capacity:
_______ lb
Rating:
_______ Btu @ ____ °F
_______ kg
________ kW @ ____ °C
Are all panels, doors, vent caps in place?
Has the unit suffered any external damage?
Damage ______________________________
Does the gas piping and electric wiring appear to be installed in a professional manner?
Has the gas and electric been inspected by the local authority having jurisdiction?
Is the gas supply properly sized for the equipment?
Were the installation instructions followed when the equipment was installed?
Have all field installed controls been installed?
Do you understand all the controls on this equipment? If not, contact your wholesaler or rep. (DO NOT START
this equipment unless you fully understand the controls.)
Remarks: _____________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
GENERAL
With power and gas off.
Make certain all packing has been removed.
Tighten all electrical terminals and connections.
Check damper linkages for tightness.
Check all fans and blowers for free movement.
Check all controls for proper settings.
GAS HEATING
With power and gas on.
Inlet gas pressure. ____ in. wc or ____ kPa
Burner ignition.
Manifold gas pressure. ____ in. wc or ____ kPa
Cycle firestat and/or freezestat.
Check electronic modulation. Set at: __________
Cycle and check all other controls not listed.
Check operation of remote panel.
Entering air temp. _____ °F or ____ °C
Discharge air temp. (high fire) ____ °F. or ____ °C
External static pressure _________ in. wc
Cycle by thermostat or operating control.