Soleus SGCAC08ESE Bedienungsanleitung

 11 

Open the window the maximum amount to allow for clearance of the cabinet. The crank handle 

should be removed to allow the platform to be fastened to the jamb. If the window cannot open far enough 
(more than 15-1/2 inches) for the cabinet to clear the window, remove the window entirely by drilling out the 
rivets. Bolts can serve as the pivots in the future. 
 

To avoid crank handle and window clearance problems, the unit can be installed in a stationary sash section. 
However, the horizontal mullion and the 2 glass panels must be removed before installation. 

 

as shown. Use 

the adjustment bolt and hex flange nut to complete 
the assembly. Choose the slot and adjustment bolt 
hole locations that will create a 45 degree angle 
between the platform and the support brace. Try the 
assembly in the window to determine if the platform 
will rest properly, and allow the proper slope (3/16- 
inch lower on outside). 

If you are planning to use a siding protec-

tion board (see Step 6) on the outside of your 
house, hold the board in place when testing the 
assembly in the window. 
 

in the 

window jamb an equal distance from each side of the 
jamb, and 3/16-inch up from the window sill. If the 
hole coincides with the window lever slot in the jamb 
bottom, an additional hole will have to be drilled 
through the platform edge and the window jamb to 
miss this slot. 
 

from the track 

seal, and stick the seal to the window sill on the 
outside of the bottom jamb. 
 

through the pilot hole you drilled in Step 2. Use 

a #8x3/4-inch self-threading screw.