Whirlpool W10678945D Use & Care Manual

Troubleshooting

“LF” 

Lint filter removed.

Indicates that the HybridCare™ filter has been removed. Place

filter into dryer and make sure the handle is properly seated.

“PF” (power failure)

The drying cycle has been interrupted 

by a power failure.

Touch and hold START to restart the dryer. 
NOTE: The Control Lock function may be enabled when 

recovering from a power failure. To unlock the control,  

touch and hold CONTROL LOCK for at least 3 seconds.

“L2” Diagnostic Code 

(low or no line voltage 

condition)

There may be a problem with your 

home power supply, keeping the 

dryer’s heater from turning on.

The dryer will continue to run when this diagnostic code is 

present. Touch any pad to clear the code from the display  

and return to the estimated time remaining.

NOTE: This error will only show during the initial installation.
Try the following:
Check to see if a household fuse has blown or circuit breaker 

has tripped. Electric dryers use two household fuses or breakers. 

Replace the fuse or reset the circuit breaker.

Confirm that the power cord is properly installed. Refer to  

the Installation Instructions for details.

Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualified electrician.

“F# E#” (F1 E1, F3 E1, 

etc.) variable service 

codes

The dryer is in need of service.

If a code beginning with an “F” appears in the display,  

alternating between F# and E#, the dryer control has  

detected a problem that requires service. Call for service.

“Loc” or “Lc”

The Control Lock is enabled.

Touch and hold CONTROL LOCK for 3 seconds to unlock  

the controls of the dryer. During this time the LED Display  

will count down 3-2-1. When the Control Lock is disabled,  

the LED Display will clear.

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help - 

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.