Whirlpool W10392127B-SP User Manual

 

■

A location allowing for proper exhaust installation.  

See “Venting Requirements.”

 

■

A separate 15 or 20-amp circuit needed for gas dryers and 

30-amp circuit needed for electric dryers.

 

■

If using power supply cord, a grounded electrical outlet  

located within 2 ft. (610 mm) of either side of dryer.  

See “Electrical Requirements.”

 

■

Floor must support dryer weight of 200 lbs. (90.7 kg).  

Also consider weight of companion appliance.

 

■

Level floor with maximum slope of 1" (25 mm) under entire 

dryer. If slope is greater than 1" (25 mm), clothes may not 

tumble properly and automatic sensor cycles may not 

operate correctly.

 

■

For garage installation, place dryer at least 18" (460 mm) 

above floor. 

 

■

Steam models only: Cold water faucets located within 4 ft. 

(1.2 m) of the water fill valves, and water pressure of 20-100 

psi (137.9-689.6 kPa). You may use the water supply for your 

washer using the “Y” connector provided.

Do not operate your dryer at temperatures below 45° F (7°C). At 

lower temperatures, the dryer might not shut off at the end of an 

automatic sensor cycle. this can result in longer drying times.

The dryer must not be installed or stored in an area where it will 

be exposed to water and/or weather.

Check codes requirements. Some codes limit, or do not permit, 

installation of the dryer in garages, closets, mobile homes, or 

sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the 

same closet as a dryer.

The location must be large enough to allow the dryer door  

to open fully.

NOTE: Most installations require a minimum of 5" (127 mm) 

clearance behind dryer for exhaust vent with elbow. See “Venting 

Requirements.”