Whirlpool W10392127B-SP User Manual

This dryer is suitable for mobile home installations.  

The installation must conform to the Manufactured  

Home Construction and Safety Standard, Title 24 CFR,  

Part 3280 (formerly the Federal Standard for Mobile home 

construction and Safety, Title 24, HUD Part 280) or Standard 

CAN/CSA-Z240 MH.

 

■

Metal exhaust system hardware, available for purchase  

from your dealer. For further information, see “Assistance  

or Service” section in your “Use and Care Guide.”

 

■

Special provisions must be made in mobile homes to  

introduce outside air into dryer. Openings (such as a  

nearby window) should be at least twice as large as  

dryer exhaust opening.

 

■

Mobile Home Installation Hold-down Kit Part Number 

W10432680 is available to order. For further information,  

see “Assistance or Service” section in your “Use and  

Care Guide.”

 

■

To contact a qualified electrical installer.

 

■

To be sure that the electrical connection is adequate and in 

conformance with Canadian Electrical Code, C22.1-latest 

edition and all local codes. A copy of above codes standard 

may be obtained from: Canadian Standards Association,  

178 Rexdale Blvd., Toronto, ON M9W 1R3 CANADA.

 

■

To supply the required 4 wire, single phase, 120/240 volt,  

60 Hz, AC only electrical supply on a separate 30-amp 

circuit, fused on both sides of the line.  A time-delay fuse or 

circuit breaker is recommended. Connect to an individual 

branch circuit. 

 

■

This dryer is equipped with a CSA  

International Certified Power Cord  

intended to be plugged into a standard  

14-30R wall receptacle. The cord is  

5 ft. (1.52 m) long. Be sure wall receptacle  

is within reach of dryer’s final location.

If using a replacement power supply cord, it is recommended that 

you use Power Supply Cord Replacement Part Number 9831317.
For further information, please reference service numbers located 

in “Assistance or Service” section of your “Use and Care Guide.”

■  

For a grounded, cord-connected dryer: 

This dryer must be grounded. In the event of malfunction or 
breakdown, grounding will reduce the risk of electric shock 
by providing a path of least resistance for electric current. 
This dryer is equipped with a cord having an equipment- 
grounding conductor and a grounding plug. The plug must 
be plugged into an appropriate outlet that is properly 
installed and grounded in accordance with all local codes 
and ordinances.

WARNING: 

Improper connection of the equipment- 

grounding conductor can result in a risk of electric shock. 
Check with a qualified electrician or service representative 
or personnel if you are in doubt as to whether the dryer is 
properly grounded. Do not modify the plug provided with 
the dryer: if it will not fit the outlet, have a proper outlet 
installed by a qualified electrician.

All dimensions show recommended spacing allowed, with tested 

spacing of 0" (0 mm) clearance on sides and rear. 

 

■

Additional spacing should be considered for ease of 

installation and servicing.

 

■

Additional clearances might be required for wall, door, and 

floor moldings.

 

■

Additional spacing should be considered on all sides of the 

dryer to reduce noise transfer.

 

■

For closet installation, with a door, minimum ventilation 

openings in the top and bottom of the door are required. 

Louvered doors with equivalent ventilitation openings are 

acceptable.

 

■

Companion appliance spacing should also be considered.