Vermont Casting DVT38S2 사용자 설명서

9

Your fireplace is approved to be vented either through 
the side wall, or vertical through the roof.

• 

• 

Venting terminals shall not be recessed into a wall or 
siding.

• 

Horizontal venting must be installed on a level plane 
without an inclining or declining slope.

There must not be any obstruction such as bushes, gar-
den sheds, fences, decks or utility buildings within 24” 
(610mm) from the front of the termination hood.
Do not locate termination hood where excessive snow 
or ice build up may occur. Be sure to check vent termi-
nation area after snow falls, and clear to prevent ac-
cidental blockage of venting system. When using snow 
blowers, make sure snow is not directed towards vent 
termination area.
Location of Vent Termination 
It is imperative the vent termination be located observ-
ing the minimum clearances as shown on following 
page.

FP1225

Fig. 10  Honeywell ignition module.

1    2    3          5    6    8     9