Juniper Networks M10i Benutzerhandbuch

is attached to a proper earth ground. For more information about ESD, see

3.

Remove the Routing Engine as described in 

 on page 121.

4.

Use needlenose pliers with grooved jaws to pull the wire clasp out from under
the compact flash disk and lift it up (see 

5.

Use the needlenose pliers to gently grasp the compact flash disk and slide it out
of the connector. Place the compact flash disk on the antistatic mat or in the
electrostatic bag.

Figure 49: Removing the Internal Flash Drive

Inserting the Internal Compact Flash Disk

To insert the internal compact flash disk, follow this procedure (see 

):

1.

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see

2.

If the compact flash disk is in a PCMCIA card adapter, slide it out of the adapter.

3.

Slide the compact flash disk into the connector on the Routing Engine (see

).

4.

Use needlenose pliers with grooved jaws to lower and secure the wire clasp.

5.

Replacing Routing Engine Components

■

127

Chapter 13: Replacing Hardware Components