Summit HL-630 OPC Benutzerhandbuch

 

24

 

engine is the Okidata OL-400/800, but the first 
actual reset procedure is for the OL-800 series only, 
followed by other machines that use the same engine 
but have different reset procedures. Just to make 
things a little crazier, there are also machines that 
use different engines, but use the same reset 
procedure. These are grouped as above, but with a 
note that says what other machines also use that 
procedure. 
Hopefully this will help clear up some of the 
confusion on what procedures to use. 

 

 

B4200: 
Start the status monitor for the printer. Click on the 
Printer Setup Tab-Printer Menu Button-Maintenance 
1 Tab. Click the (RESET) button next to the drum 
counter, then click on OK button to reset the drum 
counter.  
 
B4300: 
Press the ONLINE button to return the printer to off 
line status. Press the MENU button until 
MAINTENANCE MENU is displayed, then press 
the SELECT button. Press the ITEM button until 
DRUM COUNT RESET is displayed. Press the 
SELECT button and drum counter is reset. 

Press the MENU button until the display shows 
“paper menu”.  Press NEXT 4x until the display 
shows “System Menu”. Press SELECT 1x until the 
display shows “Factory defaults”. Press NEXT 7x 
until the display shows “Reset Toner Life”. Press 

SELECT 1x until the display shows “Resetting 
Toner page Count”. Press READY 
 
 
 

 

 

Unlike most of the other Okidata machines, these 

cartridges use a chip that has to be replaced. It uses 

an odd round style ship, and there are many 

manufacturers using them. Most have different 

chips. Make sure you have the correct chip for the 

machine it is intended for. 

 

 

NOTE: I have not seen these cartridges or machines. 
When a new cartridge (OEM) is installed, it should 
clear the message. (You have to install it with the 
power off). If the power is left on. It will not reset 
itself, then the following complicated procedure 
must be followed. At this point I do not know if the 
cartridge has a reset gear or a chip. 

Enter the PCU Diagnostic mode by turning the 
printer off and holding down the MENU and OK 
buttons on power up. (Release the buttons once you 
are in the PCU DIAG MODE). Press the MENU 
button 14x until the display shows “COUNTER 
DISPLAY”.  Press the MENU button and the 
BACK?C button at the same time. This will put the 
printer into the “Feed Counter Clear Mode”. Release 
the buttons. Press the up arrow 5x until the display 
shows “Toner Counter Clear”. Pres the OK button, 
the display will show “Toner No”. Press the Up 
Arrow 1x so the display shows “Toner Yes”, Press 
the OK button. The Green data light will flash to 
indicate the process is complete. Turn the printer off 
and on to clear the PCU DIAG mode.