Summit HL-630 OPC Benutzerhandbuch

 

37

 

The developer is rated for 30,000 pages. The default 
setting on the machine is to keep running even after 
the 30K pages. That default setting can be set by the 
dealer to stop at 30K pages. It is considered a dealer 
option. 
 
To enter the simulation mode, press the "CLEAR 
KEY", "INTERRUPT KEY", "0" KEY", 
"INTERRUPT KEY", "MAIN CODE" "START 
KEY", "SUB CODE" "START KEY",  
"Main code" for clearing the developer = 42 
"SUB CODE" for clearing the developer = 1 
The developer count is now cleared. 
To exit the simulation mode press the "CLEAR ALL 
KEY" 
Turn the machine off and on. 

Inside the drum cover, there is a gear with a “Flag” 
on it. Remove the gear and place it so the flag is at 
the 12:00 position. This flag when the cartridge is 
installed, will turn down, and engage a switch in the 
machine. This tells the machine there is a new drum. 
If the drum unit has never been rebuilt, this flag gear 
is not there. It can be ordered from Sharp, but there 
is also a reset that can be done through the menu 

To enter the simulation mode, press the "CLEAR 
KEY", "INTERRUPT KEY", "0" KEY", 
"INTERRUPT KEY", "MAIN CODE" "START 
KEY", "SUB CODE" "START KEY",  
 
"Main code" for clearing the developer = 24 
"SUB CODE" for clearing the developer = 7  The 
drum count is now cleared. 
To exit the simulation mode press the "CLEAR ALL 
KEY" Turn the machine off and on. 
 

 
 
 

 

 

 
The toner cartridges in these machines have a chip 
that must be replaced each cycle. The chip is located 
on the gear end of the cartridge.  Replacement toner 
and chips are available. 

 

 

 

The toner cartridges in these machines have a chip 
that must be replaced each cycle. The chip is located 
in a pocket in the cartridge. It can be held in place by 
either 2 clips, 1 screw, or 2 screws. Replacement 
toner and chips are available. 
 

 

 
 
 

 

The Sharp JX-9200 engine has many variations. The 
known reset procedures are listed by machine model 
#, and cartridge part #.