Primera Technology LX900 Benutzerhandbuch

The sensor can only be moved a maximum of 2.3 inches 

from the left side of the printable area. This means that the

maximum diameter circular label that can be printed is 4.6 

inches. For circular labels larger than 4.6 inches in diameter,

you must have a 

black mark

 printed on the back of the label

stock. This means that you must change the Stock Sensor Mode

to Reflective. The printer will now look for the black mark 

representing the beginning of the next label instead of the 

diecut. For more information on changing the Stock Sensor

Mode see Section 2D.

Through-Hole Labels
If you are using card stock or label stock that has a hole punch

or a notch to identify a transition from backing to label, you

can adjust the Stock Sensor to position it over the identifying

mark. 

Center

of Circle

1/2”

Center

of Hole

Through-Hole Labels

Circular Labels

Set Sensor Bar to 1 1/8" for 2" circular label (1/8" liner edge gap).

LX900.qxd  1/14/2010  12:41 PM  Page 12