Primera Technology LX900 Benutzerhandbuch

D. SET THE STOCK SENSOR MODE

The stock sensor mode refers to the method the printer will use

to detect the print starting position for each label. To adjust the

stock sensor mode, open the 

PTStatus

 program.  PTStatus

automatically installs with your printer driver and can be

accessed through the printer driver or as program that is 

accessible in the same manner as all other programs.  

1. Connect the printer via USB and turn on the power.  The

Stock Sensor Mode setting is stored on printer main board

so you will not be able to access it unless the printer is

turned on and properly communicating with the computer.

2. Go to Start - Programs - Primera Technology - PTStatus

.

3. Click on the 

Alignment Tab

 (3rd tab from top).

4. Click on the Stock Sensor Mode button.
5. Select the Stock Sensor Mode by clicking on graphic that

most closely corresponds to the stock you intend to install.  

There are three sensor modes:

 (Default). If you are using standard die-cut labels that

look similar to the graphic use this setting regardless of the

size of the label.  Also, use this setting for Through-hole label

material where a hole is punched through each label or a notch

is cut in the side. 

. Use Reflective for label material where a black 

pre-printed line (black mark) on the back of the label stock

indicates the break between labels.  Black marks are required

on clear label stock rolls, or label where the label waste matrix

(waste) is left on the liner. Black marks can also be used for

irregular shaped labels, circles larger than 4.6 inches or on any

stock where the print starting position can not be sensed using

the label itself.

LX900.qxd  1/14/2010  12:41 PM  Page 13