Lowrance electronic X515C DF Benutzerhandbuch

Power Diagram B

Use this method if you are only powering your display unit and are not

powering a NMEA 2000 network or any NMEA 2000 accessory device.

(Fuse may be different from that shown.)

Powering a NMEA 2000 Network Bus

A NMEA 2000 bus must be connected to a power source to operate.

NMEA 2000 devices draw their power from the network bus.
If you have a pre-existing NMEA 2000 network installation, it may al-

ready be connected to another power source. If you are not sure about a
network's power status, consult the boat manufacturer or dealer. If your

NMEA 2000 bus is already powered, you can ignore the NMEA 2000

Power cable and use the method shown in Power Diagram B above.

Never attach two power sources to a single NMEA 2000 bus.
If you do need to power your NMEA 2000 bus, attach the NMEA 2000

Power cable to an accessory switch as indicated in power diagram A on

page 27. The NMEA 2000 Power cable's red wire should be attached

(with provided 3-amp fuse) to the positive (+) terminal. The NMEA

2000 Power cable's black and shield wires should both be attached to

the negative (–) terminal.
WARNING:

The NMEA 2000 network bus is always on and constantly
drawing power. You must connect NMEA power to a
switched power source so you can turn off the network

Red wire with

3-amp fuse

Black wire

Recommended
power off switch

Data Cable

To unit

NMEA 2000 Power Cable

White wire
(unused)

12 volt DC

power source

All unused Data
or NMEA 2000
power wires
should be
capped with
wire nuts and
electrical tape
to prevent
shorts.

Display Unit
Power Cable