Quantum DLT-S4 Anleitung Für Quick Setup

 2U Rackmount Quick Start Guide

2

Connecting the Interface and Power 

Cables

0

1 Shut down and turn off the selected host server. Turn 

off all attached accessory devices, such as printers and 
other SCSI devices.

2 Connect the interface and power cables to the back of 

the 2U Rackmount, following the instructions below for 
the type of interface you are using. 

SCSI (SDLT 320, SDLT 600, DLT-S4, LTO-3) (see 

figure 2

)

a) Connect one end of the SCSI cable to one of the 

SCSI connectors on the back of the 
2U Rackmount. Connect the other end of the 
SCSI cable to the host.

b) Connect the SCSI terminator to the adjacent 

SCSI connector on the back of the 2U 
Rackmount.

c) Each SCSI device must have its own unique SCSI 

ID. Change SCSI ID(s) if necessary. 
Note: Any time you change the SCSI ID, you 
must turn the drive power off and then back on 
using the power button on the front of the 2U 
Rackmount.

d) Connect the power cable.  

Fibre Channel (SDLT 600, DLT-S4) (see 

figure 3

)

a) Remove the protective cap(s) from the Fibre 

Channel port on the back of the 2U Rackmount. 

b) Remove the protective covers from the ends of 

the Fibre Channel cable. 

c) Connect one end of the Fibre Channel cable to 

the Fibre Channel port on the back of the 
2U Rackmount. Connect the other end of the 
Fibre Channel cable to the host.

d) Connect the power cable.

W

ARNING

: For maximum stability, the equipment rack 

should be securely bolted to the floor per the rack 
manufacturer’s recommendations.

After installing components in the equipment rack, 
do not pull out more than one component on its 
slide rails at a time. If the equipment rack is not 
securely bolted to the floor, the weight of more than 
one extended component could cause the 
equipment rack to become unstable, tip over, and 
cause damage, serious bodily injury, or death.

N

OTE

: Be sure to connect the cables on the same 

side of the 2U Rackmount as the tape drive(s) 
you will be using. 

Figure 2  SCSI Connections   

Figure 3  Fibre Channel 
Connections 

3 Plug in the power cable to the nearest properly 

grounded power outlet.

4 Turn on the 2U Rackmount by pressing and holding the 

power button on the front panel for one second. The  
green power LED should illuminate. See 

Figure 4  Power Button and Fan  
LED 

 

  

5 Turn on any other devices you turned off earlier.
6 Turn on the host server.

C

AUTION

: An illuminated fan LED (the left LED on the 

front panel) indicates a fan failure (see 

Confirm that this has not occurred. If the fan LED is 
illuminated, contact Quantum (