Quantum DLT-S4 Anleitung Für Quick Setup
2U Rackmount Quick Start Guide
3
Installing a Tape Drive in the
2U Rackmount
0
Follow these instructions to install a second tape drive or to
reinstall a tape drive after it has been removed for servicing.
reinstall a tape drive after it has been removed for servicing.
1 Turn off the 2U Rackmount by pressing and holding the
power button on the front panel for three seconds.
2 Disconnect the power cable from the back of the
2U Rackmount.
3 Slide the 2U Rackmount out of the equipment rack.
4 Loosen the captive thumbscrews securing the top cover.
4 Loosen the captive thumbscrews securing the top cover.
Slide the cover forward, then lift up to remove it. See
figure 5
.
Figure 5 Removing the Top Cover
5 Install two thumbscrews into the side of the tape drive
that will be located next to the outer wall of the
2U Rackmount. See
2U Rackmount. See
for
thumbscrew locations.
C
AUTION
: Before performing this procedure, you must
turn off the 2U Rackmount and disconnect it from its
power source.
power source.
N
OTE
: Extra thumbscrews are stored inside the
2U Rackmount (see
). Use the type
appropriate for your unit: SDLT 320 tape drives
use 6-32 (silver) thumbscrews; all other tape
drives use M3 (black) thumbscrews.
use 6-32 (silver) thumbscrews; all other tape
drives use M3 (black) thumbscrews.
Figure 6 General Thumbscrew
locations
locations
Figure 7 Specific Thumbscrew
Locations and Types
Locations and Types
Extra
thumbscrews
thumbscrews
SDLT 320 (6-32)
LTO-3 (M3)
SDLT 600 (M3)
DLT-S4 (M3)