Quantum DLT-S4 Anleitung Für Quick Setup
2U Rackmount Quick Start Guide
5
Figure 10 DLT-S4 SCSI
Figure 11 SDLT 600 Fibre
Channel
Channel
Figure 12 DLT-S4 Fibre Channel
Brown wire
location
location
SCSI ID Enable
Jumper
TERMPWR
Jumper
Figure 13 LTO-3
7 Lower the tape drive into the slot in the 2U Rackmount,
sliding the thumbscrews into the openings in the outer
wall of the 2U Rackmount. Slide the tape drive all the
way into the 2U Rackmount until it stops. See
wall of the 2U Rackmount. Slide the tape drive all the
way into the 2U Rackmount until it stops. See
Figure 14 Sliding the Tape Drive
Into the 2U Rackmount
Into the 2U Rackmount
8 Secure the tape drive to the 2U Rackmount by installing
two thumbscrews through the bottom set of mounting
holes in the inner wall of the 2U Rackmount and into
the tape drive. See
holes in the inner wall of the 2U Rackmount and into
the tape drive. See
. Use the correct
thumbscrew type (indicated in the Note for
step 5
).
Brown wire
location