Quantum DLT-S4 Betriebsanweisung
Chapter 10 Installing an Internal Fibre Channel Tape Drive
Connecting the Cables
DLT-S4 Product Manual
86
Connecting the Cables
10
Connect the Fibre Channel and power cables as follows:
1
Ensure that both the tape drive and computer are turned off.
2
Insert the fiber optic cable into the Fibre Channel port on the rear of
the tape drive (see
The connector is fully seated when it snaps into the port.
3
Insert the other end of the fiber optic cable into the Fibre Channel
port on the host computer.
4
Locate an available DC power cable in the host computer and attach
it to the power connector on the rear panel of the tape drive (see
). The connector is keyed, preventing improper connection.
(See
number assignments and signal names.)
5
Check all cable connections to ensure that they are attached correctly,
seated firmly, and secured.
seated firmly, and secured.
Note:
If you are connecting several devices to the system,
connect only the tape drive to the host computer at this
time. Finish the installation procedure and confirm that
the host computer and tape drive are communicating
correctly before adding additional devices (see