Quantum DLT-S4 Betriebsanweisung
Chapter 9 Installing an Internal SCSI Tape Drive
Setting TERMPWR
DLT-S4 Product Manual
77
Setting TERMPWR
9
At least one device on the bus must supply terminator power
(TERMPWR).
• To enable TERMPWR — Install a jumper across pins 11 and 12 on the
• To enable TERMPWR — Install a jumper across pins 11 and 12 on the
SCSI jumper block (see
• To disable TERMPWR — Remove the jumper.
Figure 29 Enabling TERMPWR
TERMPWR Enable jumper
on jumper block
on jumper block
denotes pin #12
denotes pin #11