Quantum DLT-S4 Betriebsanweisung
Chapter 9 Installing an Internal SCSI Tape Drive
Using the Loader/Library Interface Connector
DLT-S4 Product Manual
79
4
Connect all additional tape drives and peripheral devices to the host
computer’s SCSI cable.
5
Ensure that a terminator is installed on the very last SCSI connector
on the SCSI cable.
6
Check all the cable and termination connections to ensure that they
are attached correctly and seated firmly.
7
Turn on power to the system and all attached devices.
8
Confirm the installation (see
Using the Loader/Library Interface Connector
9
This connector is only used for tape drives installed in loaders/libraries.
If your system requires it to be used, it should have been pre-assembled
at the factory. For more information about the loader/library connector,
see
Note:
Regardless of which device terminates the SCSI bus, that
device must have power applied and be powered on for
proper termination to occur.