Cisco Cisco Prime Collaboration Assurance 11.5 Weißbuch
© 2016 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 25 of 64
Device
SNMP HTTP CLI JTAPI MSI
CDP
Notes
Cisco Cius
-
-
-
-
-
-
● The Cisco Cius endpoints are discovered either
through Cisco Unified CM or Cisco VCS (access
credentials are not required). You must enable web
access in Cisco Unified CM for these.
credentials are not required). You must enable web
access in Cisco Unified CM for these.
● Credentials are not required for HTTP access.
● End-to-end troubleshooting is not supported.
● End-to-end troubleshooting is not supported.
However, the path trace can be discovered from the
first-hop-router (FHR) if router CLI access is provided
for Cisco Prime Collaboration.
first-hop-router (FHR) if router CLI access is provided
for Cisco Prime Collaboration.
Cisco IP phones (89xx, 99xx)
-
-
-
-
-
-
● The Cisco IP Phones endpoints are discovered
through Cisco Unified CM. You must enable web
access in Cisco Unified CM for these.
access in Cisco Unified CM for these.
● These video phones require Cisco Unified CM
application user to have the additional role Standard
CTI Allow Control of Phones supporting
Connected Xfer and conf.
CTI Allow Control of Phones supporting
Connected Xfer and conf.
● Credentials are not required for HTTP access.
● End-to-end troubleshooting is not supported.
● End-to-end troubleshooting is not supported.
However, the path trace can be discovered from the
first-hop-router (FHR) if router CLI access is provided
for Cisco Prime Collaboration.
first-hop-router (FHR) if router CLI access is provided
for Cisco Prime Collaboration.
Cisco DX70 and DX80
(supported by Prime
Collaboration Assurance 10.5.1
and later versions)
(supported by Prime
Collaboration Assurance 10.5.1
and later versions)
-
-
-
-
-
-
● The Cisco Phone endpoints are discovered through
Cisco Unified CM. You must enable web access in
Cisco Unified CM for these.
Cisco Unified CM for these.
● These phones require Cisco Unified CM application
user to have the additional role Standard CTI Allow
Control of Phones supporting Connected Xfer and
conf.
Control of Phones supporting Connected Xfer and
conf.
● Credentials are not required for HTTP access.
● End-to-end troubleshooting is not supported.
● End-to-end troubleshooting is not supported.
However, the path trace can be discovered from the
first-hop-router (FHR) if router CLI access is provided
for Cisco Prime Collaboration.
first-hop-router (FHR) if router CLI access is provided
for Cisco Prime Collaboration.
Border Element, Gatekeeper,
H323 Gateway, SIP Gateway
MGCP Gateway, SRST Device,
Voice Gateway
H323 Gateway, SIP Gateway
MGCP Gateway, SRST Device,
Voice Gateway
-
-
-
-
-
-
Access Credentials for the Devices That Need to Be Managed
Establishing these access credentials is critical for successfully deploying Cisco Prime Collaboration
Assurance and Analytics.
Before you do anything, make sure all the credentials are in place on the devices and that they are all collected
in a reliable way so that they can be correctly entered in the Cisco Prime Collaboration Assurance application.
After you’ve entered the credentials, you will be able to verify them for the devices being managed. Only after
successful validation can you start discovering the devices to be managed.
Below is an example of access credentials configuration and validation for Cisco Unified Communications
Manager:
1. Enable and configure SNMP on Cisco Unified Communications Manager
a. Configure an SNMP Community String