Vogelzang International Stove TR008 Benutzerhandbuch

Seite von 22
Page  
DURANGO™
 
TR008 / 050207.2
Fig. 10 - Chimney Construction Through Roof
Fig. 11 - Chimney Connection to Firebox  
Through Masonry wall
ChImNEY CONNECTIONS continued …
mANUFACTURED CHImNEY
REFER  TO  CHIMNEY AND  CHIMNEY 
CONNECTOR MAKER’S INSTRUCTIONS FOR 
INSTALLATION AND USE.
Use only 6” diameter listed chimney UL 103 
HT  type.  Chimney  made  to  this  listing  is  High 
Temperature rated to 2100 degrees Fahrenheit. Use 
chimney from only one manufacturer. Never mix 
brands. Carefully follow the chimney manufactur-
er’s stated requirements and clearances. Use the 
chimney manufacturer’s attic guards, roof supports, 
flashing and fire stops when passing through a ceil-
ing. Use a listed thimble when passing through a 
combustible wall. Do not use makeshift compro-
mises during installation. 
Never use a single-
wall connection pipe as a chimney!
When using a pre-existing chimney, have it’s 
condition  and  installation  inspected  before  us-
ing. Make sure that the chimney meets all of the  
UL  rating  requirements  listed  above.  Be  aware 
that  not  all  manufactured  chimney  is  of  the  
UL 103 HT type.
NOTE:  It  is  recommended  that  you  con-
tact a licensed heating and cooling contractor 
(consult your local yellow pages) for chimney 
installation.
Manufactured chimney with the proper required 
UL listing is available from most home centers, 
hardware stores, and HVAC supply stores.
If you have access to the internet, you may 
wish to view chimney manufacturers’ informa-
tion on-line. See, www.duravent.com, www.
selkirkinc.com, or www.mtlfab.com.
VENTING TO ExISTING FIREPLACE
In some instances, people desire to convert an 
existing fireplace for stove use. Usually, safe con-
nection to an existing masonry chimney requires 
more  work  than  using  a  prefabricated  chimney. 
The existing fireplace must be closed and sealed at 
the damper with high-temperature caulk, ceramic 
wool, or furnace cement. Prior to installation, clean 
and inspect the existing flue and smoke shelf. In-
stallation should be designed so the system can be 
dismantled for periodic cleaning and inspection. 
Before conversion, make sure the existing chimney 
is structurally sound, the chimney incorporates a 
flue liner and make sure it is in good condition. 
(A flue liner consists of clay tile that protects the 
brickwork  of  a  chimney.  If  a  chimney  does  not 
have a liner, or it is damaged, have it relined by a 
Continued on next page